The top-of-form position is the position on the page where the printer starts printing. When you resume printing, the printer automatically feeds the paper back to the top-of-form position and begins printing. Press the Pause button to turn off Micro Adjust mode.
If you try to adjust the tear-off position beyond these limits, the printer beeps and stops moving the paper. The printer has a minimum and a maximum tear-off position. Open the paper guide cover, then press the LF/FF button to feed paper backward, or press the Load/Eject button to feed paper forward, until the paper perforation is aligned with the tear-off edge of the paper tension unit.Ī. The Pause light begins flashing and the printer enters the Micro Adjust mode. Hold down the Pause button for about three seconds. You may need to press the Tear Off/Bin button to advance the paper to the tear-off position. Make sure the Tear Off/Bin light is flashing (the paper is at the current tear-off position). Your tear-off position setting remains in effect until you change it, even if you turn off the printer. Never use the knob to adjust the tear-off position this may damage the printer or cause it to lose the tear-off position. If your paper's perforation is not aligned with the tear-off edge, you can use the Micro Adjust function to move the perforation to the tear-off position.įollow these steps to adjust the tear-off position: The Micro Adjust function allows you to move the paper forward or backward in 0.141 mm (1/180-inch) increments so that you can make precise adjustments to the top-of-form and tear-off positions.